Enable combustion models

September 22, 2005, 12:24

Dear All!

I want to use a combustion model. How do I activate it? The TUI says these models are currently "disabled". What does it mean? I tried using the particular command say: "premixed-combustion?" in the species menu.In response, I get a "Invalid Command" message. Why this is happening? Is this due to incomplete installation OR combustion models are to be activated differently? Can it be because I am not supplied with thiese models due to licensing terms i.e. they need some special license?

any advice is highly appreciated.

Thanx for all your help!

Swarup.

September 23, 2005, 04:27

Did you enabled species transport (define\models\species\transport&reaction)?

If not, that's the source of your problem.

Razvan

September 23, 2005, 07:29

Thanx a lot for your suggestion. I got help from FLUENT Support team.

Swarup.

September 22, 2005, 12:24	Enable combustion models	#1
Swarup Guest Posts: n/a	Dear All! I want to use a combustion model. How do I activate it? The TUI says these models are currently "disabled". What does it mean? I tried using the particular command say: "premixed-combustion?" in the species menu.In response, I get a "Invalid Command" message. Why this is happening? Is this due to incomplete installation OR combustion models are to be activated differently? Can it be because I am not supplied with thiese models due to licensing terms i.e. they need some special license? any advice is highly appreciated. Thanx for all your help! Swarup.

September 23, 2005, 04:27	Re: Enable combustion models	#2
Razvan Guest Posts: n/a	Did you enabled species transport (define\models\species\transport&reaction)? If not, that's the source of your problem. Razvan

September 23, 2005, 07:29	Confusion cleared	#3
Swarup Guest Posts: n/a	Thanx a lot for your suggestion. I got help from FLUENT Support team. Swarup.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Openfoam combustion models:	Kalaiselvan M	Main CFD Forum	0	December 27, 2007 07:00
Different combustion models in two domains-how?	tony	CFX	3	October 2, 2007 13:13
Are combustion models actually any use?	None given	Main CFD Forum	22	September 24, 2005 11:37
Review ignition models for ICE combustion	Berny	Main CFD Forum	0	June 3, 2005 04:34
COMBUSTION MODELS	stefano	Siemens	1	May 15, 2003 07:09