CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

Edge with One sided thread

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   October 14, 2005, 06:10
Default Edge with One sided thread
  #1
Kshitij
Guest
 
Posts: n/a
In my application I have created a small rectangular face inside a bigger one with its edges defined with interior boundary condition. However when I read the mesh file in Fluent6 it gives an error msg saying that the edges of the inner face are only one sided threads. How can I make the edges of inner face two-sided? I need the interior boundary condition on the inner edges. thanks Kshitij
  Reply With Quote

Old   October 14, 2005, 09:00
Default Re: Edge with One sided thread
  #2
Jason
Guest
 
Posts: n/a
The "only one adjacent cell thread" warning comes because fluent only sees a mesh on one side of the edge. It has to do with how you modeled the faces. There are two possibilities here... one is that you have two triangles, one on-top of the other. Or you have a big traingle with a hole the size of the small triangle, and you have a small triangle to fill that hole, but the edges aren't connected. If the big traingle doesn't have a hole in it the shape of the small triangle, then all you have to do is use the split command (split the big triangle with the little one, making sure the connected option is turned on... this will leave you with a big traingle with a hole in it, a little triangle to fill the hole, and they will be sharing the three edges). If the big triangle does have a hole in it, then you have to manually connect the edges (in the edge commands, it's in the top row of icons second from the right... it looks like a black plug). This way the two faces are now sharing the three edges. You'll probably have to remesh, and you might have to reset your BCs.

Hope this helps, and good luck, Jason
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
how to set periodic boundary conditions Ganesh FLUENT 13 January 22, 2014 04:11
udf problem jane Fluent UDF and Scheme Programming 11 December 4, 2012 03:09
Actuator disk model audrich FLUENT 0 September 21, 2009 07:06
Phase locked average in run time panara OpenFOAM 2 February 20, 2008 14:37
fluent add additional zones for the mesh file SSL FLUENT 2 January 26, 2008 11:55


All times are GMT -4. The time now is 09:19.