|
[Sponsors] |
October 16, 2005, 08:26 |
grid generation of type C
|
#1 |
Guest
Posts: n/a
|
I'm using structured grid generation of type C, in numerical simulation of flow about NACA airfoil. The flow supposed 2D, incompressible, viscous and laminar. The method of discretization is finite volumes with second order upwind scheem. For coupling velocities with pressure i'm using SIMPLER algorithm. My problem diverge after a difference of velocity 1.e-3 between two consecutive iterations.
Is that caused by the dimension of grid generation (191x141)and the stretching parameters (0.12,0.12)? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Free jet simulation | msarkar | OpenFOAM Running, Solving & CFD | 39 | May 11, 2021 13:21 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
turbulent jet simulation | antonio_ing | OpenFOAM Running, Solving & CFD | 5 | September 16, 2010 02:31 |
pipe flow with heat transfer | Fabian | OpenFOAM | 2 | December 12, 2009 04:53 |
reconstructParMesh not working with an axisymetric case | francesco | OpenFOAM Bugs | 4 | May 8, 2009 05:49 |