Home > Forums > Software User Forums > ANSYS > FLUENT

How to set boundary of polymer swelling?

Mark Forums Read

Reply

Search this Thread

November 10, 2005, 05:46	How to set boundary of polymer swelling?	#1
ST Guest Posts: n/a	I have the problem about polymer flow behavior in extruder.I use power law model for my simulation. Polymer melt is injected from die that appear swelling at exit. Now, I want to set free surface boundary at swelling surface. Can someone tell me how to set this boundary?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mesh file for flow over a circular cylinder	Ardalan	Main CFD Forum	7	December 15, 2020 13:06
how to set rotating boundary?	conan	FLUENT	2	April 6, 2012 00:22
How to set a oblique incidence wave Boundary	shiw	FLOW-3D	2	March 6, 2011 19:15
set up boundary	ritmat	FLUENT	5	July 24, 2007 03:38
how to set boundary condition	Huairong Huang	Phoenics	4	April 30, 2006 12:31

All times are GMT -4. The time now is 09:33.