 |
 |
 |
|
|
|
[Sponsors] | ||||
Boundary Profile computed with different model |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 17, 2005, 05:23
|
Boundary Profile computed with different model
|
#1 |
|
Guest
Posts: n/a
|
Hello, I simulated an incompressible flow throught a duct with the K-Epsilon Model. Then I copied the boundary profile at a plane near the outlet and used its components as the inlet conditions in another simulation, where I used the realizable K-Epsilon Model. Can i do that, or does it cause trouble? What if i would use this profile in a simulation with the RSM Model? Kind Regards Gerd
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Boundary Profile | E61 | FLUENT | 0 | January 5, 2011 08:13 |
| boundary layers and k-w model | paul | Main CFD Forum | 1 | December 8, 2009 02:01 |
| Water vapour condensation in CFX-5.7.1 | hdj | CFX | 1 | November 27, 2005 07:15 |
| New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 06:18 |
| Please help with flow around car modelling! | Tudor Miron | CFX | 17 | March 19, 2004 19:23 |
Linear Mode
