 |
 |
 |
|
|
|
[Sponsors] | ||||
influence of time step in insationary simulation |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 1, 2005, 09:08
|
influence of time step in insationary simulation
|
#1 |
|
Guest
Posts: n/a
|
Hello
i´m trying to get Residence time distributions (RTD) from a Fluent simulation. Therefore I monitor the facet average of the concentration of a Tracer that was entered at the entrance. Unfortunately the result depends on the time step size in the instationary simulation. How can it be that the result depends on the time step size? What can possibly be the mistake i´m making? Any help is greatly appreciated. Best wishes Sascha |
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
| Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |
Linear Mode
