Change Courant number from UDF -- CFD Online Discussion Forums

December 1, 2005, 05:16	Change Courant number from UDF	#1
HS Guest Posts: n/a	Hello! Is it possible to change the Courant number from a UDF? I'm doing an unsteady calculation, so I cannot cancel the iterations to change the Courant number manually, as this would cause the solver to take a new time step when it begins again... Anybody got any ideas? Thanks a lot! /Henrik

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Courant Number Problems	wschosta	OpenFOAM Running, Solving & CFD	5	February 28, 2020 03:45
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
Running stably with a large Courant number using pimpleFoam	mlawson	OpenFOAM	11	November 29, 2014 10:37
Courant Number in unsteady problems...	vandadt	FLUENT	0	November 8, 2009 16:12
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

All times are GMT -4. The time now is 14:16.