 |
 |
 |
|
|
|
[Sponsors] | ||||
December 8, 2005, 23:32
|
Pulsating flow in Fluent
|
#1 |
|
Guest
Posts: n/a
|
I am currently trying to model a simple tube that is 2D-axisymetric. On the left hand side I want to specify an oscillating pressure funtion which I have as a UDF. On the opposite end of the tube I would like to specify the opposing velocity as a UDF which will be out of phase with the pressure inlet. Is there a way to do this? I have trid this which not much luck. To put it simply, I would like to be able to have the fluid be pushed through the tube at high deltaP and pulled back through at the low deltaP. Any help with this would be greatly appreciated.
Thanks Ryan |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flow Development in Fluent | sth | Main CFD Forum | 0 | November 30, 2010 11:26 |
| Two Phase Flow and Fluent | Mach_v | FLUENT | 1 | October 7, 2010 02:02 |
| reversed flow in unsteady simulation with dynamic mesh (fluent 12.1) | zhaoyu_001 | FLUENT | 0 | April 7, 2010 00:24 |
| swirling flow in simpleFoam compared with FLUENT | belinda | OpenFOAM Running, Solving & CFD | 0 | November 2, 2009 03:57 |
| Inviscid Drag at subsonic, subcritical Mach # | Axel Rohde | Main CFD Forum | 1 | November 19, 2001 12:19 |
Linear Mode
