|
[Sponsors] |
December 23, 2005, 04:23 |
Optimum mesh?
|
#1 |
Guest
Posts: n/a
|
Hi all,
I wonder, what is the optimum mesh I can create in Gambit? The examine mesh tool gives e.g. the skewness of the elements. The optimum would be, that the bars on the left of the histogram will be large and those on the right will be small. But that's not always possible. So what is the highest skew angle allowed? What is about the other parameters like volume, edge ratio and so on, what are the best values here?? Regards Ralf |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
optimum mesh for LES of channel flow | Hefny | Main CFD Forum | 0 | September 28, 2008 11:24 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |