 |
 |
 |
|
|
|
[Sponsors] | ||||
December 26, 2005, 10:32
|
Lift and Drag Coefficients Reliability
|
#1 |
|
Guest
Posts: n/a
|
I am simulating some easy NACA 0012 performances (stall, cero lift, etc.) but the Drag and Lift coefficients Fluent computes don't fit NACA 0012 theoretical curves that I have.
Are realiable Lift and Drag coefficients computed by Fluent? Do you know why I get those wrong results and where my mistake could be? Thanks in advance. Luis |
|
|
||
|
December 27, 2005, 12:41
|
Re: Lift and Drag Coefficients Reliability
|
#2 |
|
Guest
Posts: n/a
|
Hello did you adapted the reference values in the reference panel?
|
|
|
|
||
|
December 27, 2005, 14:45
|
Re: Lift and Drag Coefficients Reliability
|
#3 |
|
Guest
Posts: n/a
|
Hi Bob, thanks for your reply.
Yes, I changed the reference values. I tried many possible values for them, but any result I got was right. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| lift and drag coefficients around a ground vehicle | Pedro | CFX | 3 | September 5, 2012 18:31 |
| how to set lift and drag coefficients in force mon | alagesanj | FLUENT | 0 | November 16, 2008 20:47 |
| Calculation of lift and drag coefficients | Prachi | CFX | 3 | August 14, 2007 14:05 |
| Lift and Drag Coefficients | xdm | Siemens | 7 | April 8, 2007 17:55 |
| pressure. lift and drag coefficients | waqar mahboob | Main CFD Forum | 0 | July 25, 1998 03:34 |
Linear Mode
