|
[Sponsors] |
January 5, 2006, 08:59 |
Meshing a hole geometry
|
#1 |
Guest
Posts: n/a
|
I tried to Hex/cooper mesh a cylinder, this cylinder has hole on the one side of the wall (for another fluid inlet, apart from the inlet from downside), however unable to succeed,Plz suggest the Hex/cooper meshing scheme.
Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[GAMBIT] error meshing volume on sedan geometry | AbdulAzis | ANSYS Meshing & Geometry | 20 | October 13, 2015 02:16 |
[ICEM] Meshing of 3d flywing geometry | sfs | ANSYS Meshing & Geometry | 24 | November 17, 2011 04:49 |
Reg difficulties in meshing the geometry...Urgent | arunraj | ANSYS Meshing & Geometry | 0 | August 26, 2011 23:25 |
[ANSYS Meshing] Help - Meshing 2 Surfaces On A 2D Geometry | Ali_M | ANSYS Meshing & Geometry | 4 | March 29, 2011 03:01 |
meshing geometry in gambit | soundar | FLUENT | 1 | January 7, 2005 02:59 |