problems orientating profile

January 19, 2006, 02:48

Hi,

I want to read in the boundary profile xxx into my simulation as a velocity inlet. The profile xxx has the same orientation and the same size as the surface in my geometry that is defined as velocity inlet.

But when I start iterating, it turned out, that the profile at the velocity inlet is 90° turned to the original profile xxx.

Now I used define->profiles->orient to orient my profile. After that, the only message is

"warning: no x,y or z points specified in profile xxx"

And I can not iterate...

What is the problem?

Ralf

P.S. has someone the online help for the version 6.2.16 ?? I can only access the 6.0 ant the 6.1 documentation

asal · March 30, 2014, 10:00

Dear Ralf Schmidt

Do you find any solution of the issue. I have the exact same problem as you had!

January 19, 2006, 02:48	problems orientating profile	#1
Ralf Schmidt Guest Posts: n/a	Hi, I want to read in the boundary profile xxx into my simulation as a velocity inlet. The profile xxx has the same orientation and the same size as the surface in my geometry that is defined as velocity inlet. But when I start iterating, it turned out, that the profile at the velocity inlet is 90° turned to the original profile xxx. Now I used define->profiles->orient to orient my profile. After that, the only message is "warning: no x,y or z points specified in profile xxx" And I can not iterate... What is the problem? Ralf P.S. has someone the online help for the version 6.2.16 ?? I can only access the 6.0 ant the 6.1 documentation

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Needed Benchmark Problems for FSI	Mechstud	Main CFD Forum	4	July 26, 2011 12:13
Some problems with Star CD	Micha	Siemens	0	August 6, 2003 13:55
Making boundary profile on a surface in xz- plane	varghese	FLUENT	6	May 3, 2002 08:38
how to obtain a profile ...	olivier	FLUENT	2	December 13, 2001 06:21
Boundary conditions profile	Christophe Doublet	FLUENT	1	June 14, 2001 00:27

March 30, 2014, 10:00		#2
asal Senior Member Astio Lamar Join Date: May 2012 Location: Pipe Posts: 186 Rep Power: 13	Dear Ralf Schmidt Do you find any solution of the issue. I have the exact same problem as you had!