|
[Sponsors] |
January 15, 2006, 00:34 |
ABORT in DPM
|
#1 |
Guest
Posts: n/a
|
Hi All, I have a problem about abort in DPM. How to figure which cell is going to ABORT? There is no interaction between the continunous and partical phase. Thank you very much. Lisa
|
|
January 16, 2006, 03:54 |
Re: ABORT in DPM
|
#2 |
Guest
Posts: n/a
|
Hello Are u using injection model. Manojkumar
|
|
January 16, 2006, 13:55 |
Re: ABORT in DPM
|
#3 |
Guest
Posts: n/a
|
Yes, I am using injection model. Lisa
|
|
January 17, 2006, 06:50 |
Re: ABORT in DPM
|
#4 |
Guest
Posts: n/a
|
U first do laminar and then Tarbulent. After converge this u directly on the energy and set the injection. u define the droplet in injection type and define the co-ordinate as well all the parameter given in this box. First u read the injection setting. This one help u. Manojkumar
|
|
January 18, 2006, 00:14 |
Re: ABORT in DPM
|
#5 |
Guest
Posts: n/a
|
Thank you very much. Lisa
|
|
January 19, 2006, 02:10 |
Re: ABORT in DPM
|
#6 |
Guest
Posts: n/a
|
Hi Lisa,
Are u using liquid fuel injection. If yes please tell me that u got converge solution by the way sugested by Manoj.If possible please write the steps u performed in the injection. Thanking you |
|
January 20, 2006, 01:31 |
Re: ABORT in DPM
|
#7 |
Guest
Posts: n/a
|
Hi Sonal, I am sorry I did not use liquid fuel injection. I am using surface injection of solid particles. Best, Lisa
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DPM modeling | Mohsin | FLUENT | 0 | March 31, 2010 22:11 |
DPM ABORT | supriya | FLUENT | 3 | March 12, 2009 02:35 |
DPM - do the particles affect the liquid? | Nikhil Dani | FLUENT | 0 | January 1, 2009 11:58 |
How can i abort DPM calculations from a UDF | Aris | FLUENT | 0 | April 15, 2008 05:19 |
slow after mesh for enhanced wall treat DPM | joshkemp | FLUENT | 0 | May 1, 2007 17:20 |