 |
 |
 |
|
|
|
[Sponsors] | ||||
January 25, 2006, 08:20
|
3D airfoil boundry conditions
|
#1 |
|
Guest
Posts: n/a
|
hi,
i am doing a 3D airfoil simulation for abt a mach no. of 0.2 ... the grid is created .... the entry region is a hemisphere and the exit is shaped in the form of a cylinder... THIS IS FOR 0 ANGLE OF ATTACK. ... inlet region has tetrahedral elements whereas exit one has hexahedral elements ... and so a default wall is created in between... during simulation, I setup the interface = symmetry,, and farfield = symmetry , outlet as pressure-outlet and inlet as velocity inlet .... neone please help me through this. .. when I iterate its diverging ... some temp/pressure AMG solver problemmmm.... OR PLEASE TELL ME THE BOUNDARY CONDITIONS YOU HAVE APPLIED ... if neone has done this earlier.... thanx a lot for reading, sarat |
|
|
||
|
July 15, 2009, 08:09
|
3D airfoil simulation..
|
#2 |
|
New Member
Chih Fang
Join Date: Jul 2009
Posts: 18
Rep Power: 16  |
cancelled.. thanx..
Last edited by cfang; July 20, 2009 at 22:27. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| Varying Inlet Angle of Attack for Structured Hexahedral C-Grid around an Airfoil | Josh | CFX | 11 | June 22, 2010 21:27 |
| [FloWorks] Request advice for an airfoil calculation problem | Bogey Jammer | Main CFD Forum | 0 | September 29, 2009 17:06 |
| Initial conditions for airfoil in c-grid | zonexo | Main CFD Forum | 0 | December 20, 2005 01:55 |
| Boundry Conditions | Parshant Dhand | FLUENT | 2 | January 10, 2003 20:25 |
Linear Mode
