 |
 |
 |
|
|
|
[Sponsors] | ||||
January 21, 2006, 23:50
|
Heat transfer from solid to liquid
|
#1 |
|
Guest
Posts: n/a
|
Having trouble getting this to work. How do I set the interface. I have a coupled interface between a solid and liquid zone but no heat flux results! Any ideas? Thanks you
|
|
|
||
|
January 24, 2006, 18:19
|
Re: Heat transfer from solid to liquid
|
#2 |
|
Guest
Posts: n/a
|
Have u set the bc for the wall?
thomas |
|
|
|
||
|
January 30, 2006, 04:10
|
Re: Heat transfer from solid to liquid
|
#3 |
|
Guest
Posts: n/a
|
I too have same problem I have set up boundary as wall ....but i thik it is not right ....can any one guide on this issue...my problem is reverse ....in my problem DO model is used and i got result for air and I am getting a flow of air alos but though wall is near heated air ir is not getting heated.......
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Two-sided Wall Heat Transfer BC - No Separate Solid Mesh and No Heat Transfer Coeff | swahono | OpenFOAM Running, Solving & CFD | 10 | October 15, 2018 05:43 |
| Heat Flux at wall in a conjugate heat transfer problem | Chander | CFX | 2 | July 9, 2011 22:22 |
| No Heat Transfer between two solid domains | Mike ZH | CFX | 7 | July 26, 2008 16:50 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
| free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |
Linear Mode
