CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Problems with porous jmp boundary type

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   January 31, 2006, 18:08
Default Problems with porous jmp boundary type
  #1
Marijo
Guest
 
Posts: n/a
Hi,

I am modeling a filter/screen in Fluent. I have difficulties in using porous jump boundary type in 2D.I select an edge for porous jump but when I try to export it, it says that poruous jump does not contain any valid entity and is not written. Manual says that poruous jump is a type of internal face zone.What does it mean?

Thank you.
  Reply With Quote

Old   January 31, 2006, 23:49
Default Re: Problems with porous jmp boundary type
  #2
Muhammad Shakaib
Guest
 
Posts: n/a
I think you should make two sections. One for the incoming and other for the after the filter. The edge separating the incoming and outgoing (sections) can be defined as porous jump
  Reply With Quote

Old   February 1, 2006, 06:14
Default Re: Problems with porous jmp boundary type
  #3
edi
Guest
 
Posts: n/a
It sounds weird; as a matter of fact the porous jump BC must be applied to an internal face zone, therefore a line in 2d or a face in 3d. I always applied this boundary to internal faces in 3d and never had any problem...you can try to set your edge as "interior" in gambit and then change it into porous jump in fluent and see what happens...

Hope this helps,

Edi.
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Wind turbine simulation Saturn CFX 58 July 3, 2020 02:13
boundary conditions for simpleFoam calculation foam_noob OpenFOAM Running, Solving & CFD 8 July 1, 2015 09:07
[blockMesh] Cyclic BC's: Possible face ordering problem? (Channel flow) sega OpenFOAM Meshing & Mesh Conversion 3 September 28, 2010 13:46
pipe flow with heat transfer Fabian OpenFOAM 2 December 12, 2009 05:53
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues michele OpenFOAM Meshing & Mesh Conversion 2 July 15, 2005 05:15


All times are GMT -4. The time now is 20:12.