CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Setting a surface roughness on a wall (http://www.cfd-online.com/Forums/fluent/39466-setting-surface-roughness-wall.html)

Sandile Peta February 1, 2006 05:35

Setting a surface roughness on a wall
 
What if modeling a laminar flow airfoil therefore using a laminar model, how do you specify a wall roughness then.

Bogdan February 3, 2006 08:09

Re: Setting a surface roughness on a wall
 
in the laminar flow you cannot specify the wall roughness. I tried also very hard. The only solution is to turn on a turbulence model - then is available!


All times are GMT -4. The time now is 20:26.