Faces link

February 3, 2006, 08:38

Hi, I'm trying to link two faces for mesh, one over the other, that have 36 holes (the two faces are the upper and bottom sides of the distributor of a hydraulic turbine). I selected the two faces and one edge of each loop but when I apply I receive this message:

error "two faces have inconsistent lower topology".

But there aren't problems in the geometry. Have someone an idea to solve the error? Thanks in advance to everyone

February 6, 2006, 08:54

Problably you have one loop on a face with a different number of edges of the correspondent loop on the other face. Hope this helps

February 3, 2006, 08:38	Faces link	#1
Pamela Guest Posts: n/a	Hi, I'm trying to link two faces for mesh, one over the other, that have 36 holes (the two faces are the upper and bottom sides of the distributor of a hydraulic turbine). I selected the two faces and one edge of each loop but when I apply I receive this message: error "two faces have inconsistent lower topology". But there aren't problems in the geometry. Have someone an idea to solve the error? Thanks in advance to everyone

February 6, 2006, 08:54	Re: Faces link	#2
Emanuele Guest Posts: n/a	Problably you have one loop on a face with a different number of edges of the correspondent loop on the other face. Hope this helps

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
DecomposePar unequal number of shared faces	maka	OpenFOAM Pre-Processing	6	August 12, 2010 09:01
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 19:43
Problem in IMPORT of ICEM input file in FLUENT	csvirume	FLUENT	2	September 9, 2009 01:08
Unaligned accesses on IA64	andre	OpenFOAM	5	June 23, 2008 10:37