WARN: Boundary Entity wall.4 does not contain any

February 4, 2006, 16:02

hi

created a wind tunnel with solid constraints in it(3d), meshed it and have given the boundary conditions as follows

inlet, outflow; wall1, wall2,wall3,wall4(bottom of the wind tunnel).

When I try to export it to fluent i got this warning error

WARN: Face.29 is not meshed and is not exported WARN: Boundary Entity wall.4 does not contain any valid entity and is not written.

February 4, 2006, 18:08

The message tells you that the face is not meshed... so please check the GAMBIT file. You may duplicate faces where one is meshed and other is not. The same is true for wall.4.

February 4, 2006, 16:02	WARN: Boundary Entity wall.4 does not contain any	#1
Neelima Guest Posts: n/a	hi created a wind tunnel with solid constraints in it(3d), meshed it and have given the boundary conditions as follows inlet, outflow; wall1, wall2,wall3,wall4(bottom of the wind tunnel). When I try to export it to fluent i got this warning error WARN: Face.29 is not meshed and is not exported WARN: Boundary Entity wall.4 does not contain any valid entity and is not written.

February 4, 2006, 18:08	Re: WARN: Boundary Entity wall.4 does not contain	#2
AK Guest Posts: n/a	The message tells you that the face is not meshed... so please check the GAMBIT file. You may duplicate faces where one is meshed and other is not. The same is true for wall.4.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Domain Imbalance	HMR	CFX	5	October 10, 2016 05:57
Implementation of boundary conditions for FVM	Tom	Main CFD Forum	7	August 26, 2014 05:58
Meshing Issues: Boundary Entity.....	nevvo	ANSYS Meshing & Geometry	0	April 20, 2011 11:20
Concentric tube heat exchanger (Air-Water)	Young	CFX	5	October 6, 2008 23:17
Boundary conditions?	Tom	Main CFD Forum	0	November 5, 2002 01:54