|
[Sponsors] |
WARN: Boundary Entity wall.4 does not contain any |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 4, 2006, 16:02 |
WARN: Boundary Entity wall.4 does not contain any
|
#1 |
Guest
Posts: n/a
|
hi
created a wind tunnel with solid constraints in it(3d), meshed it and have given the boundary conditions as follows inlet, outflow; wall1, wall2,wall3,wall4(bottom of the wind tunnel). When I try to export it to fluent i got this warning error WARN: Face.29 is not meshed and is not exported WARN: Boundary Entity wall.4 does not contain any valid entity and is not written. |
|
February 4, 2006, 18:08 |
Re: WARN: Boundary Entity wall.4 does not contain
|
#2 |
Guest
Posts: n/a
|
The message tells you that the face is not meshed... so please check the GAMBIT file. You may duplicate faces where one is meshed and other is not. The same is true for wall.4.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
Implementation of boundary conditions for FVM | Tom | Main CFD Forum | 7 | August 26, 2014 05:58 |
Meshing Issues: Boundary Entity..... | nevvo | ANSYS Meshing & Geometry | 0 | April 20, 2011 11:20 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
Boundary conditions? | Tom | Main CFD Forum | 0 | November 5, 2002 01:54 |