|February 15, 2006, 10:35||
boundary layers on a thin wall
Here an easy question.
I try to create boundary layers on a (infinite) thin wall. But there comes only this massage:
ERROR: Boundary Layer b_layer.5 could not be attached to the volume volume.1, Face face.25 combination, because that Face is dangling in this Volume.
I created the wall by splitting the volume with a face. I am new to Gambit and canīt find something about that in the Help file. Can somebody help me or tell me, in which chapter I can find an answer, please.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Very technical question about solving wall boundary layer ...||jlb001||FLUENT||6||December 27, 2014 06:56|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|
|Deal with wall boundary with moving mesh by FVM?||aiya||Main CFD Forum||6||May 10, 2007 11:33|
|Water vapour condensation in CFX-5.7.1||hdj||CFX||1||November 27, 2005 08:15|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|