create helical ribbon
 

please help me to create th geometrie of helical ribbon in gambit thanks

Re: create helical ribbon *NM*
 

Re: create helical ribbon by gambit
 

please help me tu create hilical ribbon by gambit

Re: create helical ribbon by gambit
 

Hi Hamina, you should try the sweep process , so you can sweep a circular surface to make a helical geometry. Please come back if there is any question. Hope that help you. Wael

Re: create helical ribbon by gambit
 

thank you if you give one exemple step by step in the gambit with the journal of gambit

Re: create helical ribbon by gambit
 

help with the example step by step in gambit or with th jouranal of gambit

Re: create helical ribbon by gambit
 

Sorry for my late response. 1-make a circular Omesh (if the cross section is a circle) 2-make a vertex in the center of the circle 3. make a line using the rotate vertex option using this point, you can put the angle (360 for one turn ---720 for two turns etc.) and put the pitch too. 4. make the volume of the helical geometry by the sweep face command and select the circular face and the line mad in step 3. 5.now you can mesh the volume or in step 1 mesh the circular face as you like, also, mesh the line made in step 3. Using sweep face with mesh that will mesh the volume too. Hope that help you. My best regards. Wael

Re: create helical ribbon by gambit
 

thank you for your kindness is what you puver to give me an example on gambit on the journal of the gambit

Re: create helical ribbon by gambit
 

I have to test but its does not go if you vouler gives me a numerical example if it like to you

gambit helical ribbon creation
 

can anyone plz specify the series of steps to creat helical ribbon in gambit......