error in modelling

February 17, 2006, 03:52

Dears, hi,

I was trying to model a cylinder of dia. 4m and height 5 m. its having holes of 7 mm by 7 mm on its periphery. if i create this model and mesh it , once i read it in fluent, it shows the following error..

error access : unbound variable error objective : phase domain ?

how to avoid this error. Further it has following error also ...

number of nodes read does not match number referenced

Please if someone can help in this issue. THANKING YOU .

February 18, 2006, 05:44

Probably there are more than one faces(or edges) for a single face. Therefore the unnecessary faces should be deleted before exporting in Fluent.

February 17, 2006, 03:52	error in modelling	#1
amv Guest Posts: n/a	Dears, hi, I was trying to model a cylinder of dia. 4m and height 5 m. its having holes of 7 mm by 7 mm on its periphery. if i create this model and mesh it , once i read it in fluent, it shows the following error.. error access : unbound variable error objective : phase domain ? how to avoid this error. Further it has following error also ... number of nodes read does not match number referenced Please if someone can help in this issue. THANKING YOU .

February 18, 2006, 05:44	Re: error in modelling	#2
Muhammad Shakaib Guest Posts: n/a	Probably there are more than one faces(or edges) for a single face. Therefore the unnecessary faces should be deleted before exporting in Fluent.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Modelling unsteady 2D aerofoil drag	xlxc34	Main CFD Forum	0	June 24, 2011 04:42
Advice on multi-phase flow modelling	Martin	Main CFD Forum	3	October 14, 2008 05:16
Unsteady modelling technique?	Carlos	FLUENT	0	September 26, 2008 11:37
how to ensure that your modelling is correct	rvndr	Main CFD Forum	7	March 1, 2004 12:21
Computational Modelling of Vortex Separators	May Lim	Main CFD Forum	6	November 13, 1998 12:36