CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Problems in boundary layer meshing (

Henriques February 17, 2006 15:40

Problems in boundary layer meshing
Hi all,

I am using boundary layer in GAMBIT to create a dense mesh near the wall. I am getting following error messeage:

Warn: Mesh sizes on the face channel is is smaller than geometric tolerences. Use larger mesh sizes or larger geometry.

What could be the mistake. I have tried many combinations of boundary layer parameters and also meshing of edges. But same warning.


Erdem February 18, 2006 06:54

Re: Problems in boundary layer meshing
yes I have the same problem in gambit so I make only surface mesh in gambit and export the surface to Tgrid making BL and then 3d mesh...Its very easy to create BLs in tgrid... install Tgrid then we can talk ok?

All times are GMT -4. The time now is 20:04.