Initialization of interface in VOF

dongshancfd · March 6, 2018, 23:11

Hey guys,

I have a problem when I set the initial interface in VOF. I set the volume of fraction of each cell, but the initial interface is jagged line. I wonder how can I make the initial interface smooth.

LuckyTran · March 7, 2018, 00:04

Your mesh is discrete so it will always look jagged. Smoothing to make it look pretty is a post-processing issue.

dongshancfd · March 7, 2018, 01:38

Quote:

Originally Posted by LuckyTran

Your mesh is discrete so it will always look jagged. Smoothing to make it look pretty is a post-processing issue.

Jagged line is intrinsic in discrete description. However, in this case, 100 grids are specified in x-direction and the Fluent presents 14 steps in a sinusoid interface. As is shown in the attached picture, the interface could be not so jagged. What I want is a interface constructed by 100 piecewise line but not 15. Please do me a favor.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
How to use the CFX periodic interface	zhihuawan	CFX	61	January 15, 2018 16:20
VoF, Width of interface between immiscible fluids, how to define sharp interface?	yulu	FLUENT	2	December 19, 2017 03:41
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 06:28
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55

March 7, 2018, 00:04		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,668 Rep Power: 65	Your mesh is discrete so it will always look jagged. Smoothing to make it look pretty is a post-processing issue.