|
[Sponsors] |
February 20, 2006, 12:31 |
fluctuate residual
|
#1 |
Guest
Posts: n/a
|
Dear all,
I'm running non-premixed combustion and use DPM to inject fuel and moisture (on the same surface).As iterating is going on, the residual keep fluctuating. i've tried changing my no. of iteration/DPM and increase max no. of steps but it didn't work. Any advice? Thank you in advance -Am- |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transsonic nozzle with rhoSimpleFoam | Unseen | OpenFOAM Running, Solving & CFD | 8 | July 1, 2022 06:54 |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |