Can't figure which cell particle is going to -- AB -- CFD Online Discussion Forums

February 21, 2006, 18:13	Can't figure which cell particle is going to -- AB	#1
am Guest Posts: n/a	Dear All, I'd never seen this msg."Can't figure which cell particle is going to -- ABORT" .Anyone have any ideas what's the reason? I injected fuel and moisture on the same (plane+bounded) surface.I'd run the same method like this before but the difference is at first case, i've created the surface in the gambit and set it as a wall in BC. Then, i injected the fuel and moisture from the plane. I would like to hear any advice/suggestion.Thanks in advance. -Am-

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can't figure which cell particle is going to	rookie	FLUENT	3	December 8, 2017 09:07
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 21:58
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
Warning 097-	AB	Siemens	6	November 15, 2004 04:41
Can't figure which cell particle is going to?	Easycad	FLUENT	4	November 13, 2003 07:18

All times are GMT -4. The time now is 18:48.