|
[Sponsors] |
February 22, 2006, 11:27 |
Adapt Y+/Y*
|
#1 |
Guest
Posts: n/a
|
Hi!
How do I know what values of the y+ lie between? F.ex it will lie in the range of 20 < y+ < 60? Does it depent on the size of the thing I am simulating, what fluid I am using etc.? Should I adapt the obstacle and the wall above with different values, when I want to know about the values around the obstacle (2D channel flow, drag-coefficiant etc). I am not sure if I have understood it correctly. Any help would be greatly appreciated! Thank you, Christine |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to adapt region? | gholamghar | FLUENT | 3 | April 5, 2009 23:57 |
Adapt mesh without modifying boundary layer cells? | Freeman | FLUENT | 0 | February 22, 2009 15:11 |
different between adapt and mark region? | fadhil majnis | FLUENT | 0 | November 10, 2008 04:29 |
How to adapt lower phase in 3 D pipe flow | K.Baker | FLUENT | 2 | July 21, 2007 16:19 |
how to adapt yplus,ystar?(standard wall function) | scott | FLUENT | 3 | October 19, 2006 05:54 |