|
[Sponsors] |
February 26, 2006, 17:50 |
How To Bend A Wall?
|
#1 |
Guest
Posts: n/a
|
I am trying to do some modeling in Fluent, but I need a starting point. I am modeling a diamond shaped airfoil in Fluent and want to model the two front surfaces bending up and down.
I already have a perscribed motion for the bending, but I do not know how to instruct Fluent to do this. If anyone has done this could you please explain how, and if there are any tutorials on this, could you please refer me to them. Thank you Andrew Clark |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Very technical question about solving wall boundary layer ... | jlb001 | FLUENT | 6 | December 27, 2014 05:56 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
[Commercial meshers] tmerge utility creates unwanted interface/walls comes in the final mesh | Shoonya | OpenFOAM Meshing & Mesh Conversion | 11 | January 20, 2012 06:23 |
UDF for wall slipping | HFLUENT | Fluent UDF and Scheme Programming | 0 | April 27, 2011 12:03 |
Quick Question - Wall Function | D.Tandra | Main CFD Forum | 2 | March 16, 2004 04:29 |