|
[Sponsors] |
March 4, 2006, 20:11 |
Error while exporting mesh
|
#1 |
Guest
Posts: n/a
|
Hi,
I have a solid model created in ProE. I imported it into GAMBIT and then created some additional edges and faces as an appendages to the original model i.e., the solid frame represents a frame and the additional appendages aere supposed to represent a flexible polymeric leaflet. This leaflet should be attched to the frame. But when I exported the mesh to Fluent, I got error messages saying that the faces of the leaflet that I created were not meshed and hence not exported. Do I need to use the connect faces/ edges comand or is it understood by Gambit that the leaflet is attached to the frame because I used some of the edges of the frame also to make the connections? Can this be the reason for the error? Please suggest something. Thanks, Vidya |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
Gambit error in exporting mesh in 3D modeling | Mazyar | FLUENT | 5 | March 31, 2004 10:50 |