|
[Sponsors] |
March 9, 2006, 04:25 |
question about using new mesh
|
#1 |
Guest
Posts: n/a
|
I saved the old case file with the grid_1. Now, just want to use grid_2 ( with same boundary as grid_1, a little bit geometry changing). How can I use the old case file to the new grid? Thanks a lot!
|
|
March 9, 2006, 12:18 |
Re: question about using new mesh
|
#2 |
Guest
Posts: n/a
|
In the text interface, enter the file menu. Use write-bc and read-bc to transfer the loads, materials, etc.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
ICEM 2D tetra mesh question | kawamatt2 | ANSYS Meshing & Geometry | 18 | March 3, 2014 10:56 |
2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 04:49 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |