|
[Sponsors] |
March 22, 2006, 02:41 |
incomplete.....DPM plz help
|
#1 |
Guest
Posts: n/a
|
hi
can any body help how to overcome the following problem i am simulating high temp molten steel flow inside 3-D reactangular domain.i am using DPM for particle tracking,i am injecting around 1000 particles from inlet after getting the particle trajectories i've got the information like tracked=1000,escaped=5,incomplete = 995 what might be the problem?i would appreciate any kind of help thanks in advanse |
|
March 22, 2006, 03:45 |
Re: incomplete.....DPM plz help
|
#2 |
Guest
Posts: n/a
|
You need to increase the time of calculation ofr dpm
|
|
March 22, 2006, 09:56 |
Re: incomplete.....DPM plz help
|
#3 |
Guest
Posts: n/a
|
hi
could u please tell me in detail how to do this? thanks in advanse |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
compilation problem with "fvPatch::lookupPatchField" | Ya_Squall2010 | OpenFOAM Programming & Development | 9 | November 15, 2021 22:01 |
Incomplete DPM | Mohsin | FLUENT | 1 | February 23, 2019 11:25 |
DPM Iteration, incomplete | rookie | FLUENT | 9 | May 18, 2016 12:08 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
incomplete particles in DPM model | elah599 | FLUENT | 1 | June 26, 2011 01:37 |