 |
 |
 |
|
|
|
[Sponsors] | ||||
March 31, 2006, 09:35
|
How can I monitor pressure at a point?
|
#1 |
|
Guest
Posts: n/a
|
Hello, I'm doing unsteady calculation and I want to monitor the pressure at a fixed point for each timestep. How can I do that in fluent? Thanks.
|
|
|
||
|
March 31, 2006, 22:20
|
Re: How can I monitor pressure at a point?
|
#2 |
|
Guest
Posts: n/a
|
1 difine point:surface--point(input cordinates of point wanted) 2 solve--monitors--surface--fill your information to dialog table(to choice "pressure" under report...
|
|
|
|
||
|
April 1, 2006, 01:53
|
Re: How can I monitor pressure at a point?
|
#3 |
|
Guest
Posts: n/a
|
Thanks a lot man!
|
|
|
|
||
|
April 5, 2006, 22:35
|
Re: How can I monitor pressure at a point?
|
#4 |
|
Guest
Posts: n/a
|
Hello, I followed your steps but the static pressure is always 0. What should I choose for 'Report Type'? I chose 'Integral'. Thanks again.
|
|
|
|
||
|
April 7, 2006, 11:44
|
Re: How can I monitor pressure at a point?
|
#5 |
|
Guest
Posts: n/a
|
Choose area weighted average. Also save the values at every time step, not every iteration.
|
|
|
|
||
|
April 8, 2006, 09:05
|
Re: How can I monitor pressure at a point?
|
#6 |
|
Guest
Posts: n/a
|
Thank you!
|
|
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |
| Problem with UDF compiling for kTkLW model | Wantami | FLUENT | 0 | July 18, 2011 05:11 |
| BlockMeshmergePatchPairs | hjasak | OpenFOAM Native Meshers: blockMesh | 11 | August 15, 2008 07:36 |
| Gmsh and samplesurface | touf | Open Source Meshers: Gmsh, Netgen, CGNS, ... | 2 | December 10, 2007 02:27 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
