CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   how to deremine boundary layer height? (http://www.cfd-online.com/Forums/fluent/40449-how-deremine-boundary-layer-height.html)

Mike April 5, 2006 05:21

how to deremine boundary layer height?
 
I have faecd a fact that from manual thet when u are going to capture near wall region you have to refine mesh at near wall region ,and your y plus should be in limit of 11.In your boundary layer there should be 10 nodes.but how to determine this hight.i.e. there should be these much nodes in this hight so that we can mesh according to that. Thaks in advance.


Ralf Schmidt April 5, 2006 09:34

Re: how to deremine boundary layer height?
 
have a look at

http://www.cfd-online.com/Forum/main.cgi?read=44320



All times are GMT -4. The time now is 23:47.