|
[Sponsors] |
April 5, 2006, 06:21 |
how to deremine boundary layer height?
|
#1 |
Guest
Posts: n/a
|
I have faecd a fact that from manual thet when u are going to capture near wall region you have to refine mesh at near wall region ,and your y plus should be in limit of 11.In your boundary layer there should be 10 nodes.but how to determine this hight.i.e. there should be these much nodes in this hight so that we can mesh according to that. Thaks in advance.
|
|
April 5, 2006, 10:34 |
Re: how to deremine boundary layer height?
|
#2 |
Guest
Posts: n/a
|
||
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 06:57 |
CREATION OF BOUNDARY LAYER | Jibran Haider | FLUENT | 3 | August 1, 2008 01:33 |
Height of boundary layer | DAK565656 | CFX | 2 | April 19, 2007 12:30 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
boundary layer thickness | 98.4F | Main CFD Forum | 1 | December 29, 2000 08:23 |