|
[Sponsors] |
April 6, 2006, 06:42 |
2 FLUIDS Question
|
#1 |
Guest
Posts: n/a
|
Hi, My name is Jordi. I am trying to simulate a motorcycle's radiator.
I have a question about how to simulate two fluids connected with walls between them. I don't know which are the best ways and the best options to enable in Fluent to achieve good results. My problem right now is I don't get a heat transfer between air and water. I mean, I have a pipe with water (350K) and the air flow around it. Well, I see a little increase of the Temperature of the air (but it's negligible) but the water is always at the same temperature. I am trying to achieve cool the water for the action of the air around the pipe. Well If anybody know how I can solve my problem, please let me know. I will be so grateful. Thanks to everybody, REGARDS, JORDI |
|
April 6, 2006, 12:25 |
Re: 2 FLUIDS Question
|
#2 |
Guest
Posts: n/a
|
You either need to merge faces in GAMBIT because your two fluid volumes don't have a common face or you need to specify the correct conductivity for the separating wall in FLUENT.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
question about uds | tanven | FLUENT | 2 | July 5, 2015 11:22 |
Question about Table applicaiton. | universez | OpenFOAM Running, Solving & CFD | 0 | January 12, 2010 20:31 |
Undergrad looking for some advice regarding carrer's in fluid's. | TossedSalad | Main CFD Forum | 1 | August 16, 2009 19:19 |
Poisson Solver question | Suresh | Main CFD Forum | 3 | August 12, 2005 04:37 |
Question from a non-Fluid person | ozzy | Main CFD Forum | 6 | September 4, 1998 04:09 |