|April 19, 2006, 10:06||
I am currently trying to create a UDF using windows operating sytem. The code I have creeated thus far is below. The idea is that in order to find out k the total system change in pressure is needed. Since I know the inlet pressure I turn the function on at the end of the chambre so that k can be calculated P1-P2 /1.004e6 . Then the value is written and then read into another equation during the next iteration.
It is not interpreted properly. Is there anyone who can offer some advice.
k = (2.56e5-(C_P(cell,thread))/(1.004e6));
else k =
|Thread||Thread Starter||Forum||Replies||Last Post|
|Compile problem||ivanyao||OpenFOAM Running, Solving & CFD||1||October 12, 2012 09:31|
|ParaView for OF-1.6-ext||Chrisi1984||OpenFOAM Installation||0||December 31, 2010 07:42|
|latest OpenFOAM-1.6.x from git failed to compile||phsieh2005||OpenFOAM Bugs||25||February 9, 2010 05:37|
|Error with Wmake||skabilan||OpenFOAM Installation||3||July 28, 2009 00:35|
|Axisymmetrical mesh||Rasmus Gjesing (Gjesing)||OpenFOAM Native Meshers: blockMesh||10||April 2, 2007 14:00|