Temperature Limited to 1.000 e+000 in a zone of do -- CFD Online Discussion Forums

May 8, 2006, 06:30	Temperature Limited to 1.000 e+000 in a zone of do	#1
Rajni Guest Posts: n/a	I am trying to simulate a heat source in a domain. For this purpose I've created a solid (box) Volume with the properties of wood. The strength of the source is 45 W (constant). However, during each iteration a message is flashed - " Temperature limited to 1.000 e+000 in 144 cells on Zone 2 in domain 1." Then I changed the geometry of the heat source zone to cylinderical, and made a denser mesh . The message during iterations was as follows: " Turbulent Viscosity limited to 5000 in 4898 cells in zone 2 domain 1. " What can I do about these omenous messages ???? The simulation is rendered unsuccessful. Thanx and Regards.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
TEMPERATURE LIMITED problem	emanuele	FLUENT	9	June 15, 2018 10:45
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 17:51
Problem in IMPORT of ICEM input file in FLUENT	csvirume	FLUENT	2	September 9, 2009 01:08
Temperature limited to 1.00 in 18 cell on zone 4	MANOJKUMAR	FLUENT	0	February 21, 2006 08:06
Sliding mesh error	Karl Kevala	FLUENT	4	February 21, 2001 15:52

All times are GMT -4. The time now is 18:45.