|
[Sponsors] |
Temperature Limited to 1.000 e+000 in a zone of do |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 8, 2006, 06:30 |
Temperature Limited to 1.000 e+000 in a zone of do
|
#1 |
Guest
Posts: n/a
|
I am trying to simulate a heat source in a domain. For this purpose I've created a solid (box) Volume with the properties of wood. The strength of the source is 45 W (constant). However, during each iteration a message is flashed - " Temperature limited to 1.000 e+000 in 144 cells on Zone 2 in domain 1." Then I changed the geometry of the heat source zone to cylinderical, and made a denser mesh . The message during iterations was as follows: " Turbulent Viscosity limited to 5000 in 4898 cells in zone 2 domain 1. "
What can I do about these omenous messages ???? The simulation is rendered unsuccessful. Thanx and Regards. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TEMPERATURE LIMITED problem | emanuele | FLUENT | 9 | June 15, 2018 10:45 |
Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |
Temperature limited to 1.00 in 18 cell on zone 4 | MANOJKUMAR | FLUENT | 0 | February 21, 2006 08:06 |
Sliding mesh error | Karl Kevala | FLUENT | 4 | February 21, 2001 15:52 |