CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   bubble columnn dynamics (

niraj May 9, 2006 06:02

bubble columnn dynamics
i m new use for gambit n fluent.i m doing a project on bubble column(radius 0.07m height=1.30m).for this i formed a 2d axis-symmetric euler simulation.for this i formed a grid by follwing: radius :10 cells *3.5mm,20 cells * 1.75mm height : 40 cells *5.0mm,110 cells *10 mm

for this i fored a vertex (real) on (0,0,0),(0.035,0,0)(0.07,0,0),(0,0.2,0)),(0.07,0.2 ,0),(0,1.3,0),(0.035,1.3,0),(0.07,1.3,0)

by joing all vertex fomred eddges expect on middle(0.035) formed virtual edges[i.e.1)vitual edge by joing real vertex (0.035,1.3,0) and(0.035,0,0) 2nd vitual edge by joing (0,0.2,0) and (0.07,0.2,0)]

so question is can i formed vitual ege by joing real vertex ?

again boundry condition : lower edge as velocity inlet upper edge as vent left edge as a axis right axis as a wall

now question is upper edge is pressure outlet or as only vent? and also i have a confusion on velocity inlet as gas sparger sparge the gas only by central nozzle with 0.3 mm orifice inlet( weather in this problem i set boundry condition to lower edge as a velocity inlet)

by exporting this edge to fluent now i m geting a error as "non-positive face area exist" and Grid check failed

please help me to fing out solution i will greatful to u

niraj mtech chemical

All times are GMT -4. The time now is 01:02.