|May 9, 2006, 06:50||
Hi i'm running a sliding mesh calculation but four of the interfaces cause this message when i'm re-reading the case files:
error access: unbound variable error object: thread type name
at the end of the case reading, it says it's building grid interfaces. the four it builds relate to the four faces that caused the error messages.
the simulation runs fine and i've checked the interface set up, which is identical to the other two dozen or so in the model. Also no problems when solving the mesh motion so there would seem to be no problem except for these messages.
|Thread||Thread Starter||Forum||Replies||Last Post|
|CFD of propeller with sliding meshes||ivanddd||Main CFD Forum||1||April 19, 2011 13:30|
|sliding meshes||betakv||OpenFOAM||1||August 12, 2009 12:34|
|sliding meshes||Tim Daly||FLUENT||3||November 20, 2008 09:20|
|sliding meshes with periodic BC's||Dan Brozozowski||FLUENT||3||June 27, 2003 07:10|
|Empty surface in sliding meshes.||Pierre Ricco||FLUENT||2||March 14, 2001 17:01|