 |
 |
 |
|
|
|
[Sponsors] | ||||
May 22, 2006, 07:32
|
Outlet Boundary Condition
|
#1 |
|
Guest
Posts: n/a
|
I am simulate with fluid fow in a channel with a heat source. I would like to set the Inlet and Outlet temperature with room temperautre. I choose the Pressure_Inlet and Pressure_Outlet, respectively.
After the convergence reached, the temperature at Outlet is higher than room temperature. What's wrong with my boundary? |
|
|
||
|
May 22, 2006, 17:18
|
Re: Outlet Boundary Condition
|
#2 |
|
Guest
Posts: n/a
|
You said you had a heat source in your model. If the inlet flow has room temperature and there is heat added to the flow then the temeperature will increase.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Outlet Pressure-flow coupled boundary condition (Windkessel) | cfdfsi | Fluent UDF and Scheme Programming | 3 | July 21, 2017 12:30 |
| Boundary Condition outlet | natantyt | FLUENT | 0 | September 27, 2010 15:30 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
| inlet and outlet boundary condition for turbomachinery solution | siamak1424 | OpenFOAM | 2 | August 15, 2009 11:14 |
| Outlet boundary condition | CN | FLUENT | 6 | May 22, 2005 09:37 |
Linear Mode
