|
[Sponsors] |
May 26, 2006, 17:23 |
How many nodes to create a mesh??
|
#1 |
Guest
Posts: n/a
|
Hi, When I try to mesh my geometry, I get error messsage saying that some of the faces have less than three boundary nodes and so couldn't be meshed. I don't understand this - why does a mesh need at least 3 boundary nodes? How does that influence meshing?
I have 2 tiny edges of the order of 1E-5 and I simply am not able to delete them or do any other modification to suppress their effect. Does someone have any suggestions to deal with this problem? Also, since my geometry is complex, I have several sharp and twisted angles, angular surfaces etc. Whatever I do, the meshing operation just fails. Any suggections???? Thanks, Vidya |
|
May 27, 2006, 14:12 |
Re: How many nodes to create a mesh??
|
#2 |
Guest
Posts: n/a
|
can you send me geometry chankhar
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] how can i delect the duplicate mesh line and nodes in interface between quad and tri? | snailstb | ANSYS Meshing & Geometry | 10 | September 26, 2013 08:19 |
[ICEM] Can't create prism layer on 2D extruded mesh | PedroC | ANSYS Meshing & Geometry | 19 | April 19, 2011 20:48 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |