CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

question urgent

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   May 27, 2006, 14:22
Default question urgent
  #1
ANJUM NAVEED
Guest
 
Posts: n/a
hi i m simulating gas cyclone with RNG k-e model using hedrahexal mesh. solution converge very fast except epsilon equation and then start to increase i m using default URF any suggestion. 2: what is relation between turbulent and flow equation. if i solve them separately i mean only simulating one of them at a time they both get converge very fast is this solution trust worthy. 3:what URF if i keep URF very low like .1 or .05 what effect it will have and solution will also right with these low urf thanks in advance Anjum
  Reply With Quote

Old   May 27, 2006, 14:43
Default Re: question urgent
  #2
chankhar
Guest
 
Posts: n/a
what is urf chankhar
  Reply With Quote

Old   May 27, 2006, 15:55
Default Re: question urgent
  #3
Amr
Guest
 
Posts: n/a
For part 2 of your question, and if you are on steady state, you can solve each of the equations (turbulence or flow) one at a time. This is when you first solve the flow, then turn the flow off, solve turbulence while flow is off, and finally, solve them together (some recommend that you use 2nd order discretization when you solve them together finally.

As for URF's, when they are low, the residues normally avoid instabilities and meanwhile, it takes longer time that the solution converge or residuals fall several orders of magnitude. Also try to use convergence indicators like mass or energy conservation (flux reports). Check Fluent guide for judging convergence in "using the solver section".

Cheers, Amr
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
question about uds tanven FLUENT 2 Yesterday 11:22
[GAMBIT] URGENT!!! "Import from GAMBIT to ANSYS-12.1 (Design Modeler/Geometry)" MDinc ANSYS Meshing & Geometry 13 September 13, 2012 09:26
URGENT!!! "Import from GAMBIT to ANSYS-12.1 (Design Modeler/Geometry)" MDinc FLUENT 1 November 24, 2010 02:59
Question about Table applicaiton. universez OpenFOAM Running, Solving & CFD 0 January 12, 2010 21:31
Poisson Solver question Suresh Main CFD Forum 3 August 12, 2005 04:37


All times are GMT -4. The time now is 19:09.