Mesh errors in small faces -- CFD Online Discussion Forums

June 3, 2006, 18:13	Mesh errors in small faces	#1
Mark Arinov Guest Posts: n/a	Hi, When I tried meshing my geometry, I could mesh the whole geometry except for two faces. These two have less than 3 boundary nodes, which prevent them from being meshed. Is there any way I can over this problem and mesh these two faces? I tried using the Clean Up operation, but was unsuccessful. Has anybody faced such problems before? If so, any ideas helpful to me?? Thanks.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Extrude Mesh without internal faces	TWaung	ANSYS Meshing & Geometry	3	May 29, 2019 05:18
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 06:21
DecomposePar unequal number of shared faces	maka	OpenFOAM Pre-Processing	6	August 12, 2010 09:01
Unaligned accesses on IA64	andre	OpenFOAM	5	June 23, 2008 10:37
How to control Minximum mesh space?	hung	FLUENT	7	April 18, 2005 09:38

All times are GMT -4. The time now is 10:10.