CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Mesh errors in small faces (http://www.cfd-online.com/Forums/fluent/41250-mesh-errors-small-faces.html)

Mark Arinov June 3, 2006 18:13

Mesh errors in small faces
 
Hi,

When I tried meshing my geometry, I could mesh the whole geometry except for two faces. These two have less than 3 boundary nodes, which prevent them from being meshed. Is there any way I can over this problem and mesh these two faces? I tried using the Clean Up operation, but was unsuccessful.

Has anybody faced such problems before? If so, any ideas helpful to me??

Thanks.


All times are GMT -4. The time now is 06:51.