How to set water surface boundary condition ??

June 8, 2006, 06:12

Hi~

I have a rectangular container filled with water. The top is the water face and the water is heated by the right heater.

I want to see the water thermally convected by outside air. And if I generate some gas in the water, the gas still can pass the water face to outside.

I know that the WALL boundary can set to CONVECTION, but the gas can not pass the WALL to the outside air.

Can anybody help me? Thank you.

Please explain it in great detail. Thank you very much.

June 8, 2006, 12:57

Can somebody help me please?

June 8, 2006, 13:42

Hi,

I suggest you to use the option Search of this forum by using: "Free surface boundary condition". You will find lots of comments about it.

Personally, I've tried different options depending on what I want to simulate. I've used pressure outlet, outflow, symmetry, and wall with stress = 0. Remember to consider the conditions of every boundary.

Regards,

HAR

June 8, 2006, 06:12	How to set water surface boundary condition ??	#1
Luke Guest Posts: n/a	Hi~ I have a rectangular container filled with water. The top is the water face and the water is heated by the right heater. I want to see the water thermally convected by outside air. And if I generate some gas in the water, the gas still can pass the water face to outside. I know that the WALL boundary can set to CONVECTION, but the gas can not pass the WALL to the outside air. Can anybody help me? Thank you. Please explain it in great detail. Thank you very much.

June 8, 2006, 12:57	Re: How to set water surface boundary condition ??	#2
Luke Guest Posts: n/a	Can somebody help me please?

June 8, 2006, 13:42	Re: How to set water surface boundary condition ??	#3
Humberto Guest Posts: n/a	Hi, I suggest you to use the option Search of this forum by using: "Free surface boundary condition". You will find lots of comments about it. Personally, I've tried different options depending on what I want to simulate. I've used pressure outlet, outflow, symmetry, and wall with stress = 0. Remember to consider the conditions of every boundary. Regards, HAR

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to set the Heat Flux boundary condition at Outlet	creddy_trddc	CFX	3	September 21, 2011 07:44
asking for Boundary condition in FLUENT	Destry	FLUENT	0	July 27, 2010 00:55
External Radiation Boundary Condition for Grid Interface	CFD XUE	FLUENT	0	July 9, 2010 02:53
External Radiation Boundary Condition (Two sided wall), Grid Interface	CFD XUE	FLUENT	0	July 8, 2010 06:49
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19