|
[Sponsors] |
June 19, 2006, 05:08 |
Meshing aerofoil
|
#1 |
Guest
Posts: n/a
|
Hello everybody,
I'm doing project under hydrofoil\aerofoil.I'm following cornell university guide (analysis of flow over aerofoil). (http://instruct1.cit.cornell.edu/cou.../airfoil/index) Previously programm was stoped during meshing aerofoil edges in gambit when i clicked "last length" obtion. Multiplying coordinates of aerofoil by 10 this problem overcame but again program clashes when I'm multiplying my previous data by 10 in "interval count" obtion .plz help me. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] 2d Aerofoil meshing in ansys ICEM | syler3321 | ANSYS Meshing & Geometry | 2 | February 3, 2012 01:59 |
Aerofoil meshing | eugene | Main CFD Forum | 1 | September 7, 2008 00:11 |
digitizing an aerofoil/ meshing problems | Simon | FLUENT | 2 | February 27, 2006 11:18 |
Meshing an aerofoil with a plain flap | Fatou | FLUENT | 0 | November 15, 2005 14:24 |
Icem Hexa 2d aerofoil meshing | Ste Lakey | CFX | 0 | August 25, 2004 07:05 |