|
[Sponsors] |
June 23, 2006, 15:48 |
Meshing problem
|
#1 |
Guest
Posts: n/a
|
Hi,
I have a complex geometry with skewed edges, small faces, large angles etc. I couldn't use the clean up commands in Gambit because it either didn't work or distorted the geometry. The geometry was created in Pro/E. I have to create a volume mesh. When I tried to do this,I get the following errors: 1. The matching of existing meshes on opposite ends of a sweep failed. 2. Splitting of existing meshes on a source face (face 213) is not implemented yet. What do these errors mean and how can they be fixed? Thanks, Vidya |
|
June 24, 2006, 04:37 |
Re: Meshing problem
|
#2 |
Guest
Posts: n/a
|
First try to do edge meshing on all the edges,..... and then do face meshing using default spacing and then do the volume meshing,....
if it doesn't work,... use other meshing softwares like hypermesh |
|
June 24, 2006, 14:47 |
Re: Meshing problem
|
#3 |
Guest
Posts: n/a
|
Hi Rams,
I tried meshing according to the heirarchy- edges, faces, volumes....... but Gambit crashed when I did this. It wouldn't mesh the volume at all. Any suggestions? |
|
June 25, 2006, 08:00 |
Re: Meshing problem
|
#4 |
Guest
Posts: n/a
|
Gambit does gives problem in meshing at the contact between two parts in geometry,... if the geometry has sharp corners or the contact area is less then it wont mesh correctly,...
what u do is u mesh all the edges with the finess u want and then mesh faces and volume without specifying anything but allowing the gambit to decide the spacing and interval,.... try this ,....... |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with querying the meshing database in CFX-Pre | ashtonJ | CFX | 18 | April 18, 2023 23:49 |
[Other] Hex meshing problem DM12 | patrick | ANSYS Meshing & Geometry | 7 | January 9, 2015 07:21 |
Strange ANSYS Meshing 13.0 Problem | brunob | ANSYS Meshing & Geometry | 3 | June 21, 2011 20:03 |
Meshing problem in GAMBIT | Vidya Raja | FLUENT | 0 | May 20, 2006 23:31 |
GAMBIT meshing problem | Gauthier Lambert | Main CFD Forum | 1 | August 3, 2000 09:22 |