|
[Sponsors] |
June 30, 2006, 04:26 |
Value in a specific point
|
#1 |
Guest
Posts: n/a
|
Hi,
I have a tube. I want to measure the pressure in a section of the tube. I can use for this the Contours tool. But I want also to get the value in some specific points of the section and I don't know how. The right mouse button with contours has not enough accuracy. I have tried creating several "point surfaces", and using some kind of report there, but I am not sure about what option I should try. Any help is appreciated. Thank you, Armando. |
|
June 30, 2006, 05:44 |
Re: Value in a specific point: Vertex or Facet??
|
#2 |
Guest
Posts: n/a
|
Hi again,
I have been working on it. I think the best way is the one I was trying: - Create several "Point Surfaces" - Use the report: "Surface Integrals" - Select "Static Pressure" But I don't know what kind of measurement must I choose there: Vertex average or Facet average?? (There is another post where this is discussed but I don't full understand it. I just want the static pressure in a point of the section) Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |
Constant velocity of the material | Sas | CFX | 15 | July 13, 2010 08:56 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |